This is our final design that Our 3D designer created which who we named Matt Seatter to finalise our design on CAD. We came up with this idea because we wanted the structure to be like a computer stand that can hold a computer and speakers at the same time. We have created this to have a personal fitted laptop space and also have a multiple space added on the top of the design that this in a physical term will balance the machine in proportion to having the bowl pressed to the ground. Around the edge of the lower part of the machine will have rubber seals along side with the bowl to restrict the amount of the unnecessary sound that this will play an effect to the programming side of this design. The idea that we have come across in this assignment is to manipulate sound by having this bowl detect sound and be programmed to control and create a completely different connection of sounds as to when this machine hears a certain tone of noise whether it is a higher frequency ratio or lower frequency ratio. This design initially came from the idea of having a straight square purchasing in a flush and square angle. Then we altered the design to then have this shaped into a hour glass type structure just to give the design a more contrasting and eye catching effect to the audience. Through out the process of creating and finalising everything and approving everything. we came cross some struggling points. We couldn't figure out a positioning of putting the laptop connected to the top of the table stand ( Our Design) We thought of some ways of having the laptop been able to just have the screen ( Monitor) just visible rather than just having the entire laptop visible. We then came up with the idea of cutting a slot on the outside of the design to the have the screen fully pushed down to its lowest angle and having the laptop angled at 45 degrees to position the laptop at the angle we need it to be in.